DESIGN OF SPHERICAL STORAGE TANK

Spherical Storage Tank Design 

The most common shape of a storage vessel is a cylinder with two heads which are either, hemispherical, elliptical or Tori-spherical. Spherical vessels have larger surface area per unit volume.

spherical storage tank design

The advantage of a sphere over a horizontal cylinder with the same volume is increased by the static head because it is a practice to let the thickness of the sphere vary from top to bottom as the pressure increases. Spheres are preferred for large capacity storage. The spherical vessel is a good choice above 10 m diameter.

An important aspect of the design of spheres for liquids is a considerable weight involved. Such spheres are normally supported upon vertical legs attached to the vessel at its equator.

In order to withstand the compressive stresses, the total cross-sectional area of the lags must increase linearly with the weight of the vessel.

The volume of a spherical vessel is proportional to the third power of the vessel diameter.

As the diameter increases, the length of the legs also increases. The weight of the legs is proportional to D⁴. An increase in the length of legs is unfavorable from the point of view of the angle of buckling and dynamic stability.

For large diameter spheres, the weight of the supports is considerable and constitutes a significant proportion of the total cost.

Sphere tank in concrete foundation

An alternative supporting structure for a spherical vessel is to rest the sphere on continuous

concrete foundation having outside diameter about 50 % of the diameter of the vessel. The shape of

the upper surface of the foundation creates evenly distributed pressure.

Another alternative for the supporting structure of a spherical vessel is to rest it over a reinforced

conical skirt structure. It has excellent dynamic properties and low buckling load.

Sphere tank in leg structure 

Horton sphere consists of the following portions

1. Cancer
2. Equator
3. Capricorn
4. Top and bottom plates

All these plates are produced by hot pressing. The fabrication of the Horton sphere by the use of spherical plates offers the following advantages.

1. The number of welded joints is reduced. This saves costs and improves the strength of the sphere.
2. Saving in raw material is achieved. The minimum thickness required as per pressure can be used.
3. Man-hours required for assembly and fabrication is reduced.
4. The overall appearance of the vessel improves due to the lesser number of welded joints

The plates are rolled to a spherical profile in four roller plates bending machine and the profile is checked by the volumetric checking template.

At the equator plate (with the column), pad (saddle) is welded and then on the pad, the column stub is welded. Normally top and bottom caps with nozzles welded and equator plates with or without welded pads (saddles) and column stubs are shop stress relieved because the columns come in contact with foundation concrete pedestal.

If the stress relieving is carried out at the site, the heat transfer from the steel column to the concrete foundation can crack the concrete pedestal and can cause a major hazard.

Cancer plates and the top are assembled on the top of the equator. Saddle plates (pads) are also assembled with equator plates.